|
Size: 1361
Comment:
|
Size: 2000
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 23: | Line 23: |
| 2x SupIV Supervisors 2x 6 port GBIC cards 2x 24 port GigE cards 1x 48 port GigE card |
* 2x SupIV Supervisors * 2x 6 port GBIC cards * 2x 24 port GigE cards * 1x 48 port GigE card |
| Line 36: | Line 36: |
| '''Configuring a port''' | '''Configuring an access layer port''' |
| Line 44: | Line 44: |
| bitumen(config-if#no shut bitumen(config-if)#end |
bitumen(config-if)#no shut bitumen(config-if)#exit |
| Line 47: | Line 47: |
| }}} ''no shut'' enables the port, ''shut'' disables '''Configuring a trunk port''' The native vlan setting here is only required if you plan on sending untagged packets from the device across the link, you can leave it out otherwise {{{ bitumen>en bitumen#conf t Enter configuration commands, one per line. End with CNTL/Z. bitumen(config)#int Gi7/2 bitumen(config-if)#switchport trunk encapsulation dot1q bitumen(config-if)#switchport mode trunk bitumen(config-if)#switchport trunk native vlan 8 bitumen(config-if)#description A trunk port bitumen(config-if)#exit bitumen(config)#write mem |
Bitumen refers to bituminous sands, which are a type of petroleum deposit.
History prior to arriving to UCC
The switch lived a happy life with Apache Energy in Perth.
UCC history
Not a lot of history yet!
Current tasks
Core switch/router
Current software configuration
Bitumen current runs Cisco IOS v12.2
Current hardware configuration
* 2x SupIV Supervisors * 2x 6 port GBIC cards * 2x 24 port GigE cards * 1x 48 port GigE card
Future plans for the machine
Given Bitumen has full Layer 3 capacity, potentially moving all NAT, firewall etc to it
Useful commands when working with Bitumen
More for Wheel than anyone else, the following might be considered useful
Configuring an access layer port
bitumen>en bitumen#conf t Enter configuration commands, one per line. End with CNTL/Z. bitumen(config)#int Gi7/2 bitumen(config-if)#switchport description demo bitumen(config-if)#switchport access vlan 3 bitumen(config-if)#no shut bitumen(config-if)#exit bitumen#write mem
no shut enables the port, shut disables
Configuring a trunk port
The native vlan setting here is only required if you plan on sending untagged packets from the device across the link, you can leave it out otherwise
bitumen>en bitumen#conf t Enter configuration commands, one per line. End with CNTL/Z. bitumen(config)#int Gi7/2 bitumen(config-if)#switchport trunk encapsulation dot1q bitumen(config-if)#switchport mode trunk bitumen(config-if)#switchport trunk native vlan 8 bitumen(config-if)#description A trunk port bitumen(config-if)#exit bitumen(config)#write mem
Thanks to:
Brad Peczka for acquiring for the club via his employer, Apache Energy Limited (to whom we are very grateful), then delivering and configuring with UCC members. [MRD], [DTK] and [CJS] for re-racking and re-patching.
