Revision 12 as of 2013-07-05 18:08:06

Clear message

Bitumen refers to bituminous sands, which are a type of petroleum deposit.

History prior to arriving to UCC

The switch lived a happy life with Apache Energy in Perth.

UCC history

Not a lot of history yet!

Current tasks

Core switch/router

Current software configuration

Bitumen currently runs Cisco IOS v12.2.

Current hardware configuration

  • Cisco Catalyst 4507R Chassis
  • 2x WS-X4515 Supervisor Engine IV
  • 2x WS-X4306-GB Gigabit Ethernet Module, 6-Ports (GBIC)
  • 2x WS-X4424-GB-RJ45 24-port 10/100/1000 Module (RJ45)
  • 1x WS-X4448-GB-RJ45 48-port 10/100/1000 Module (RJ45)

Future plans for the machine

Given Bitumen has full Layer 3 capacity, potentially moving all NAT, firewall etc to it

Useful commands when working with Bitumen

More for Wheel than anyone else, the following might be considered useful

Configuring an access layer port

bitumen>en
bitumen#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
bitumen(config)#int Gi7/2
bitumen(config-if)#description demo
bitumen(config-if)#switchport access vlan 3
bitumen(config-if)#no shut
bitumen(config-if)#exit
bitumen#write mem

no shut enables the port, shut disables

Configuring a trunk port

The native vlan setting here is only required if you plan on sending untagged packets from the device across the link, you can leave it out otherwise. Similarly, you can leave out the allowed vlan command if you're happy for it to trunk any and every vlan.

bitumen>en
bitumen#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
bitumen(config)#int Gi7/2
bitumen(config-if)#switchport trunk encapsulation dot1q
bitumen(config-if)#switchport mode trunk
bitumen(config-if)#switchport trunk native vlan 8
bitumen(config-if)#switchport trunk allowed vlan 2,3,421
bitumen(config-if)#description A trunk port
bitumen(config-if)#exit
bitumen#write mem

To show the allowed VLANs on a trunk

bitumen>en
bitumen#show int gi5/23 switchport

To add an allowed VLAN to a trunk (this example adding VLAN 4 to port 5/23)

bitumen>en
bitumen#conf t
bitumen(config)#int gi5/23
bitumen(config-if)#switchport trunk allowed vlan add 4
bitumen(config-if)#exit
bitumen(config)#exit
bitumen#write mem

Thanks to:

Brad Peczka for acquiring for the club via his employer, Apache Energy Limited (to whom we are very grateful), then delivering and configuring with UCC members. [MRD], [DTK] and [CJS] for re-racking and re-patching.


CategoryMachines