Differences between revisions 11 and 13 (spanning 2 versions)
Revision 11 as of 2012-05-01 11:56:00
Size: 1092
Editor: BobAdamson
Comment:
Revision 13 as of 2012-07-20 10:23:04
Size: 1279
Editor: DylanKerr
Comment: Added Fixing method.
Deletions are marked like this. Additions are marked like this.
Line 24: Line 24:

[1] http://arduino.cc/playground/Code/CmdMessenger
Line 27: Line 29:
Well...yeah...it hasn't really broken since it got replaced, so this process is still being worked out. Symptom: Cries of "The door's broken." Door relay doesn't activate from snack machine, dispense or serial from Merlo.
Cause: The seeduino program seems to hang.
Fix: Restart seeduino (unplug/replug), then restart vendserver.
 - [DTK]

The Door Lock

Hi All,

The modem has now been replaced with the arduino and the small 5v relay 
board. It's working for now, but it's a hack and not even properly boxed 
up. [TPG] has already modified dispense to suit it. If it breaks, I'll let 
you keep the pieces.

For posterity, here are the super-sekret settings and commands: 

Serial over USB connected to merlo, 115200 8n1
Type "2;" and it will respond with "1,The UCC door is alive;"
Type "4;" and it will respond with "1,Opening door;" , keep the lock open 
for ten seconds and then say "1,Locking door;". The command codes are 
strange numbers because I hacked the CmdMessenger [1] library example to 
do the job.

I've found using picocom to check it is easier than minicom. The following 
command* will start picocom with the correct baud rate and a command 
character of x: `picocom /dev/ttyUSB0 -e x -b 115200'

Bob

[1] http://arduino.cc/playground/Code/CmdMessenger

Fixing the door lock

Symptom: Cries of "The door's broken." Door relay doesn't activate from snack machine, dispense or serial from Merlo. Cause: The seeduino program seems to hang. Fix: Restart seeduino (unplug/replug), then restart vendserver.

  • - [DTK]


CategorySystemAdministration